Clamp-mounted conveyor guide bracket

What it is for

• A part that guides the products along the line without scratching them
• Correct a weakness of the original part instead of copying it
• Replace a part the manufacturer no longer supplies

Clamp-mounted conveyor guide bracket. A part that guides the products along the line without scratching them, made to your dimensions rather than taken off the shelf.

You do not need a 3D file to order. A dimensioned drawing, a photograph taken square-on with a ruler beside the part, or the broken part sent to us by post is enough: we rebuild the geometry and submit the file to you before anything is manufactured.

The three materials we recommend for this part. PA6-CF, our default choice: stiff, light, very low creep. This is the material for parts kept under permanent load that must not deform over time. PETG-CF: the most useful compromise in the range: the toughness of PETG plus the dimensional stability of the fibre. For when it has to be both strong and accurate. PP: living hinges and chemical resistance. It is the only material in the range that will bend thousands of times in the same place.

We make anything from a micro part up to a 350 × 350 × 350 mm envelope, from a one-off prototype to a medium production run, at high or medium precision depending on what the part actually needs. All twenty workshop materials remain available for this part, from PLA to carbon-filled PPS rated at 200 °C: if your constraint differs from the one we assumed, tell us and we change material without changing the starting price.

Why work with us. No tooling, no minimum order. Injection moulding needs a mould costing thousands of euros, paid back over tens of thousands of parts. Here there is no mould. One part costs one part. Order 1 unit or 500, the price hides no set-up fee. 20 materials, from PLA to carbon-filled PPS. From decorative work to parts that hold 200 °C, everything is produced in the same workshop. You do not have to change supplier when the requirement turns technical. Change it without paying for a new mould. A dimension to correct, a hole to move: we edit the file and print again. On a mould, the same correction costs money and takes weeks.

Your part, to your dimensions. Send us your 3D file, a dimensioned drawing, a photograph, or simply the part to be copied: we reproduce it faithfully or adapt it, from a single unit, with no tooling cost at all. The images on this page show typical work and are not contractual.

The three materials we recommend

Click a material to open its page and download the manufacturer's datasheet (PDF).

Clamp-mounted conveyor guide bracket in PA6-CF: temperature resistance 120 °C continuous; three times the price of PETG: only worth it if the load demands it; other option, PETG in most cases.

Another material is possible: tell us the real constraint (temperature, UV, impact, contact) and we will suggest one.

What we commit to

Frequently asked